logo.jpg (21604 bytes)

UNIPLEX FP-766

Fluorochemical Greaseproof Agent for Paper and Paperboard

 

 

Overview       

Uniplex FP-766 is a FDA approved, water soluble fluorochemical agent that imparts a high degree of oil and grease resistance to paper and paperboard.It also imparts a sizing effect, and water resistance. Uniplex FP-766 is listed with TSCA. CAS numbers of the active components are 65530-64-5 and65530-63-4.

The addition of Uniplex FP-766 finish to paper and paperboard does not affect texture, color, lubricity, air permeability or strength of the paper. Uniplex FP-766 can be applied by the size press, gravure or roll coating methods, or as internal sizing.  Oil and Water resistance is obtained through normal drying.  Curing at high temperature after drying is not necessary.

 

Uniplex FP-766 is Non-Flammable, and does not contain or release ozonedepleting chlorofluorocarbons (CFC's), alkylphenol ethoxylates (APE's), and does not release formaldehyde.

 

Typical         Classification……………………………Fluoroalkyl phosphate salt solution

Properties      Charge…………………………………..Anionic

                           Physical form……………………………Light pale liquid

                           Non-volatile (1 hr. @ 105°C, %)……….19.5 minimum

                           Specific Gravity (25°C)…………………1.1 ± 0.04

                           pH……………………………………….8.5 ± 1.5

                           Flash point………………………………None

                           Shipping…………………………………Non-Red Label

                           Storage…………………………………..Store at 32°F (0°C) to 100°F (38°C)

 

                           · Uniplex FP-766 has no effect on hand, color, air permeability, or

                              strength of the paper.

                           · When using paper that has been sized with rosin and/or aluminum sulfate,

                              Uniplex FP-766 should be used in conjunction with a rosin barrier.

                           · Uniplex FP-766 may be safely applied to paper and fiberboard

      designed for use as food packaging and wrapping.

   · Uniplex FP-766 complies to 21 CFR 176.170 as components in contact                                    

     with aqueous and fatty foods under conditions of use b through h of paragraph c

                              of section 176.170, Table 2.

 

 

 

Application                        Typical Formulation

                                    Penford Gum PG-270  8% Solids

                                    Uniplex FP-766                       1.2% in solution

                                    Chelation as required

 

                                    Application Method:  Horizontal size press/roll coat

                                    Curing Method:  Convection drying at 225 - 250°F for 10 - 60 seconds

 

                                    PAPER TYPE                             % WET PICK-UP         KIT VALUE

                                    50# Natural Neutral Kraft                      50-60%                                    5-7

 

Handling                 Refer to the Material Safety Data Sheet (MSDS) available for information on

Information           the safe use, handling and disposal of this product.

 

                                    The material should be stored in a location where it will not be exposed to                                      freezing temperatures.

 

 

Important                The seller makes no warranty, expressed or implied, concerning the accuracy

Notice to                   of any results to be obtained from the use of this information and no warranty

Purchaser                is expressed or implied concerning the use of these products other than

                                    indicated within.  The buyer assumes all risks of use and/or handling.  No

                                    statement is intended or should be construed as a recommendation to infringe

                                    any patent.