UNIPLEX 262
1, 4-Cyclohexanedimethanol Dibenzoate
CAS NO. 35541-81-2
UNIPLEX 262 is a solid polyol benzoate modifier for a wide range of polymers. This product is
specially suited as a cleaning material for hot melt roll coaters.
SPECIFICATIONS:
Appearance white, crystalline particles (lumps or granules)
Assay, % Ester Content 98.0 minimum
Acidity, % as Benzoic Acid 0.2 maximum
Water Content, % 0.1 maximum
Hydroxyl Number, mgKOH/g 15 maximum
Color, Pt-Co, 10% in Acetone 50 maximum
PROPERTIES
Flash Point, F°, COC 496
Melting Point, °C, Final 118
Molecular Weight 352
Odor Typical
APPLICATIONS:
Other suggested applications for UNIPLEX 262 are:
- metallic and pigmented surface coatings
- extrusion and injection molding processing aids
- polishes
- cleaning material for hot melt roll coaters
Uniplex 262 Ground is recommended and used to clean reactive hot melt off of roll coating and
laminating equipment. Uniplex 262 Ground is a white solid plasticizer supplied in ground form
for convenience. The material, when exposed to heat, will liquefy and will later resolidify after
the heat is removed. This material can then be disposed of as a solid waste.
Uniplex 262
Date Issued: 6/22/09
www.unitexchemical.com
Page 1 of 2
Supersedes: 3/23/99
ROLL CLEANING
The following procedure should be followed when cleaning roll coating equipment:
Step #1: Remove excess adhesive by reversing the rolls to permit material to squeeze off the rolls
and fall into the clean-up pan.
Step #2 Run the rolls forward, add Uniplex 262 Ground to the rolls, and allow to run for several
minutes.
Step #3 Reverse the rolls to remove excess adhesive/Uniplex 262 Ground mixture.
Step #4 Repeat Steps 2 and 3 a minimum of three times or as necessary.
Step #5 Add one last fine layer of Uniplex 262 Ground to the rolls, which will retard curing of any
residual adhesive.
Step #6 Separate the doctor roll from the applicator roll and let cool down.
All Federal, State and Local regulations, as well as common sense, should be practiced during
handling, cleaning, and disposal operations.
HANDLING
Refer to Material Safety Data Sheet
These suggestions and data are based on information we believe to be reliable. They are offered in good faith, but
without guarantee, as conditions and methods of use of our products are beyond our control. We recommend that
the prospective user determine the suitability of our materials and suggestions before adopting them on a commercial
scale. Suggestions for uses of our products should not be understood as recommendations that they be used in
violation of any patents.
Uniplex 262
Date Issued: 6/22/09
www.unitexchemical.com
Page 2 of 2
Supersedes: 3/23/99
